Harald Welte's blog
   

RSS

Harald's Web
gnumonks.org
hmw-consulting.de
sysmocom.de

Projects
OpenBSC
OsmocomBB
OsmocomTETRA
deDECTed.org
gpl-violations.org
gpl-devices.org
OpenMoko
gnufiish
OpenEZX
OpenBeacon
OpenPCD
librfid
openmrtd
opentom.org
netfilter/iptables

Categories

Archives

Other Bloggers
David Burgess
Zecke
Dieter Spaar
Michael Lauer
Stefan Schmidt
Rusty Russell
David Miller
Martin Pool
Jeremy Kerr
Tim Pritlove (German)
fukami (German)
fefe (German)
Bradley M. Kuhn
Lawrence Lessig
Kalyan Varma

Aggregators
kernelplanet.org
planet.netfilter.org
planet.openezx.org
planet.openmoko.org
planet.foss.in

Ohloh profile for laforge
identi.ca
twitter
flattr
Linked in
Xing

Creative Commons License
Articles on this blog/journal are licensed under a Creative Commons Attribution-NoDerivs 2.5 License.


blosxom


Contact/Impressum

       
Mon, 09 Apr 2012
Prototype smart card chips in DIL-40 case have arrived

Finally, the first samples of the smart card chip (for the Osmocom CardOS project) have arrived. As opposed to the final smart cards, this one has been packaged in a DIL case instead of the usual thin credit-card sized plastic. The reason for this is quite simple: This way lots of I/O pins for debugging as well as JTAG can be accessible during COS development.

Here you can see the first incarnation of a veroboard connected to an adapter pcb inside an Omnikey smart card reader:

After confirming it worked, I soldered the wires directly to the adapter PCB, as can be seen here:

There is already a real PCB design that is currently manufactured, i.e. in a week or so there will be a picture of a clean, professionally-produced/etched PCB with all of the prototype pins exported.

In terms of the COS, I haven't done much more work than compared to the last posting, mainly due to a large number of other projects. But we will get there...

[ /osmocom | permanent link ]

Name that UART: April 2012

It's sort of a cheap knock-off idea stolen from the Name that Ware on bunnies blog: I'm going to post one picture every month about a UART that I found on embedded hardware. Unfortunately I don't have much to offer in terms of a reward for whoever finds the true solution ;)

In any case, every month there are devices that I'm looking into either out of my own interest, or because the work at gpl-violations.org requires it. In most of them, you can find a UART to get to the u-boot / Linux serial console.

So here is the device that I just took apart earlier today:

The location of the UART pads was obvious, after looking at the PCB for a very short time. The entire unpopulated U1 footprint appeared suspiciously like a UART level shifter for true RS232 voltage levels:

  • You can see two signals going directly to a small unpopualted3-pin header
  • There are two other signals coming from somewhere under the main SoC
  • There are capacitors (C440, C441) directly connected to the U1 for the charge pump

[ /electronics | permanent link ]